Mounting; Fitting Top/Behind - ILD 7 Manual

Mounting

Before mounting, ensure that there is an even and secure bace. This has to be able to carry
the weight of the stove as well as the chimney and any other equipment.
There must be fire resistant floor around the stove, to protect the floor against damages
from sparks. National and local regulations always have to be followed.
If it is necessary to connect an elbow pipe a curved rather than a sharp elbow pipe is
recommended as this causes the least possible reduction in the chimney draught. See more
under general directions and chimney.
Flue connection pipe top/rear
1. By mounting in the top, remove the cover piece and connect the flue connection is
mounted with 2 pcs. bolts. (pic. 1/4)
2. By mounting on the rear side, the cover piece is removed by cutting the "treads"
with a nipper. (pic. 2)
3. Hereafter do the same with the inside coverplate. (pic 3).
4. At the end the flue connection piece can be mounted in the rear outlet (pic. 4)
(remember to move the bolted connection piece to the top outlet and mount it
here). (pic. 5)
Pic. 1
Pic. 3 Pic. 4
Pic. 2
Pic. 5
6