Advertisement
Introduction
Thank you for purchasing this quality product. To minimize the risk of injury we urge that our cli-
ents take some basic safety precautions when using this device. Please read the operation in-
structions carefully and make sure you have understood its content.
Keep these operation instructions safe.
Important safety instructions
Carefully read the instructions and keep them in a safe place so that you can refer to them at any time.
When assembling the workbench, make sure that the plastic feet are correctly attached to the
frame.
Make sure that all bolts and screws attached to the bench are securely tightened before each
use.
If the workbench is collapsed while in storage, the hexagon bolts may need to be loosened be-
fore collapsing.
Note:
Make sure that the hexagon screws are tightened again before each use.
Always keep your work area tidy and well lit. Untidy and too dark work areas increase the risk
of accidents.
Do not leave tools or other materials on the workbench when not in use.
Never use the workbench as a stepladder.
Never stand, sit, or kneel on the workbench assembled.
Never exceed the maximum load capacity of the workbench of 100 kg (220 lbs).
Always place heavy loads gently on the work surface so that the load can be absorbed gradu-
ally.
Workbench assembly instructions
st
1
step: mounting the worktop
1. Connect the bars and worktops with inward-facing notches
using wood screws.
2. Connect the movable feet to the rails with bolts (M8×14),
nuts (M8×P1.2), and washers (16×8×1.2).
2
nd
step: mounting the base frame and crossbars
1. Connect the crossbars and the base frame using bolts (M6×P1×35), washers (13×6×1.2),
and nuts (M6×P1).
2. Connect the horizontal bar to the base using screws (M5×12), washers (5×0.8), and nuts
(M6×P1).
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 62453
Page 3
04
2021-1
Advertisement
