Advertisement
RL1325_man042602
4/26/02
FAILURE TO OBSERVE THESE WARNINGS COULD RESULT IN INJURY.
THIS INSTRUCTION MANUAL CONTAINS
IMPORTANT SAFETY INFORMATION.
READ THIS INSTRUCTION MANUAL CAREFULLY
AND
UNDERSTAND
BEFORE OPERATING THIS TOOL.
• Always operate, inspect and maintain this tool in accordance
with American National Standards Institute Safety Code of
Portable Air Tools (ANSI B186.1) and any other applicable
safety codes and regulations.
• For safety, top performance and maximum durability of parts,
operate this tool at 90 psig 6.2 bar max air pressure with
3/8" diameter air supply hose.
• Always wear impact-resistant eye and face
protection when operating or performing
maintenance on this tool. Always wear
hearing protection when using this tool.
• High sound levels can cause permanent
hearing loss. Use hearing protection as
recommended
OSHA regulation.
• Keep the tool in efficient operating condition.
• Operators and maintenance personnel must be physically
able to handle the bulk, weight and power of this tool.
• Air under pressure can cause severe injury. Never direct air
at yourself or others. Always turn off the air supply, drain
hose of air pressure and detach tool from air
supply before installing, removing or adjusting
any accessory on this tool, or before performing
any maintenance on this tool. Failure to do so
could result in injury. Whip hoses can cause
serious injury. Always check for damaged,
frayed or loose hoses and fittings, and replace
immediately. Do not use quick detach couplings
at tool. See instructions for correct set-up.
• Don't force tool beyond its rated capacity.
RL1325
2:48 PM
Page 2
ALL
INFORMATION
by
your
employer
• Air powered tools can vibrate in use. Vibration, repetitive
motions or uncomfortable positions over extended periods of
time may be harmful to your hands and arms. Discontinue use
of tool if discomfort, tingling feeling or pain occurs. Seek
medical advice before resuming use.
• Place the tool on the work before starting the tool.
• Slipping, tripping and/or falling while
operating air tools can be a major cause of
serious injury or death. Be aware of excess
hose left on the walking or work surface.
• Keep body working stance balanced and firm. Do not
overreach when operating the tool.
• Do not carry tool by the hose. Protect the hose from sharp
objects and heat.
• Anticipate and be alert for sudden changes in motion during
start up and operation of any power tool.
• Tool shaft may continue to rotate briefly after throttle is
released. Avoid direct contact with accessories during and
or
after use. Gloves will reduce the risk of cuts or burns.
• Keep away from rotating end of tool. Do not
wear jewelry or loose clothing. Secure long
hair. Scalping can occur if hair is not kept
away from tool and accessories. Choking can
occur if neckwear is not kept away from tool
and accessories.
• Cutting edges and saw blades can become hot during use.
Do not touch.
• Never force the tool to cut faster or through heavier gauge
material than rated capacity.
• Do not lubricate tools with flammable or volatile liquids such
as kerosene, diesel or jet fuel.
• Do not remove any labels. Replace any damaged labels.
2
Rev. 04/26/02
Advertisement
