MAG TOOLS MB190UC Assembly Instructions

ASSEMBLY INSTRUCTIONS
Due to the weight of this cart we recommend that
TWO PEOPLE work together on the assembly. This cart weighs
approximately 200lbs, please use caution during assembly.
Step 1: Locate the key tied to the bottom shelf. Using the
key, open the sliding top and remove the caster box
from the bottom drawer. Once removed make sure all
drawers are completely closed and the inside lever is
in the locked position. Close the sliding top and lock.
Lay out a work surface using the protective foam
Step 2:
provided. Once this surface is secure gently turn the
cart onto its back. (You may choose to lay it on its top
instead)
Step 3: (Before assembling the legs remove the cable tie
holding the bumper in place) Insert the front leg
(Part #7), labeled FL or FR. Then place the front
bumper (Part # 13) over the leg aligning the center
bolt holes. With holes aligned insert stove bolt (Part
#1a) and finger tighten with nyloc nut and washer.
Step 4: Install back leg (Part #7) labeled BL or BR and bumper
(Part #13) following the same procedure as above.
MB190UC-BL / MB190UC-BK / MB190UC-OR / MB190UC-GR / MB190UC-NG / MB190UC-YE
MB190UC_Manual_031505.indd 1
Step 5: Repeat steps 3 & 4 to mount the legs on the
opposite side.
Step 6: Completely tighten the 8 bolts just inserted.
1a
Insert bottom shelf (Part # 18) between the four legs
Step 7:
flat side facing up towards the ceiling. Insert sixteen
stove bolts (Part #1a) and completely tighten.
1a
1
18
Rev. 03/16/05
3/16/05 2:11:41 PM