Front Panel - Siemens FX-C Repair Instructions

6.4

Front panel

The main characteristic of the front panel is that it reaches the floor
(there is no base panel) and it is fixed with two screws in the base of
the appliance.
6.4.1 Disassembly
► Uninstall the appliance of the niche (if it is necessary)
► Incline the appliance throw the rear part, leaving a place in the
lower part of 10 cm.
► With the screwer mat no 460621
in the base and leave the machine in the floor.
209_58300000115677_ara_en_f.doc – 26.03.08
unscrew the two screws (A)
► Remove the external ring of the gasket.
► Remove the door lock
► Pull up of the lower part of the front panel (there are two pivots
(A) in the middle of the front panel) and remove.
C: Pressure points for removing the door lock
by pressing the points (C).
Seite 21 von 34