Table of Contents
Advertisement
USING UV FUNCTION
Do not open the door mid-cycle as items will not be sterilised. If you need to add or remove
an item, cancel the cycle and start it again.
Before using this function check UV-C Bulbs are working by pressing UV Button. Both Bulbs
should glow and the Chamber will illuminate Blue, press UV twice to end cycle.
1
2
Place bottles or cups upright,
Only place clean items into
the product. Wash dirty
facing the UV light. Warning:
items with warm soapy water
Do not stack. Items need
and dry thoroughly before
to be exposed to the UV
light to sterilise. Ensure
sterilising. Tip: Efficiency
larger items do not cover or
decreases if there is residual
block the circulation vents.
moisture in the product.
4
5
x1
15 mins
x2
25 mins
x3
End Cycle
Repeatedly touch the UV
When the cycle ends the
Function Button to scroll
UV Steriliser will beep once
through to your preferred
and the interior light turns
time, if using both racks
off. Items will remain sterile
ensure you select the longer
for up to 24 hours as long
time, refer to the function
as you do not open the
& program chart on page
door.
11. The inside of the UV
Steriliser will illuminate Blue.
3
Place bottle teats upside
down in the round rings
installed on the Upper
Rack. This increases the
sterilisation efficiency. Plug
in the UV Steriliser to the
mains.
6
BEEP!
Open the door and remove
your products. Unplug the
UV Steriliser when not in
use, then follow cleaning
instructions on page 15.
12
USING DRY FUNCTION
This function
DOES NOT STERILISE. Due to this, items can
be removed or replaced mid-cycle. The countdown will continue once
the door is shut. For sterilisation use either UV or UV and Dry.
1
2
Always shake off excess
Only place clean items into
the product. Wash dirty
water from washed
items with warm soapy
products before placing
water.
in the UV Steriliser. Tip:
Efficiency decreases if there
is residual moisture in the
product.
4
5
x1 15 mins Dry
x2 20 mins Dry
x3 10 mins Deodorise Only
Repeatedly touch the Dry
When the function ends the
Function Button to scroll
UV Steriliser will beep once
through to your preferred time
and the interior light turns
and whether you would like to
off.
Dry or Deodorise your items,
refer to the function & program
chart on page 11. The inside of
the UV Steriliser will illuminate
red.
3
Place items upright, do not
stack. Ensure larger items
do not cover or block the
circulation vents. Place
bottle teats upside down in
the round rings installed on
the Upper Rack.
6
BEEP!
Open the door and remove
your products. Unplug the
UV Steriliser when not in
use, then follow cleaning
instructions on Page 15.
13
Advertisement
Table of Contents
