Replacing The Rollers; Replacing The Pick-Up Rollers - Visioneer PATRIOT P90 User Manual

M V P P90
® TM
AINTENANCE ISIONEER ATRIOT
R R
EPLACING THE OLLERS
When replacing the rollers described in this section, you should replace all of the rollers at the same time. Do not
replace just one roller and not the other. When you are finished replacing the roller, reset the roller count as
described on page 33.
Caution: Keep all replaceable parts out of the reach of children. These parts are small and pose a
choking hazard.
Turn off the scanner power then unplug the power cord from the scanner. Pull the cover release handle and open
the scanner.
When you are done replacing the rollers, close the scanner carefully pressing down on both sides of the cover
until it locks in place. Do not slam down the cover.

Replacing the Pick-up Rollers

The roller will wear out and is designed to be a user-replaceable part. A worn roller can cause documents to feed
in skewed at an angle, or multiple pages to feed at the same time. Before replacing the roller you should clean it
as excessive dust on the roller will make it appear worn and smooth. You cannot properly diagnose a worn roller
until you have cleaned it. You should generally replace the roller at 500,000 scans.
S U ' G
CANNER SER S UIDE
41