Vivotek FD9392-EHTV-O User Manual page 23

LED Definitions
Item LED status
1 Steady Red
Red LED off
Green LED off
2 Steady Red
sec.
3 Green LED blinks every 1 sec. and
LED blinks consecutively every 0.15 sec.
4 Green and RED
and RED light on, then
5 RED LED is on,
LED is constantly on.
Green and RED
Hardware Reset
The reset button is used to reset the system or restore the factory default settings.
Sometimes resetting the system can return the camera to normal operation. If the system
problems remain after reset, restore the factory settings and install again.
Reset: Press the recessed reset button. Wait for the Network Camera to reboot.
Restore: Press and hold the reset button until the status LED rapidly blinks. Note that all
settings will be restored to factory default. Upon successful restore, the status LED will
blink green and red during normal operation.
and Green LED blinks every 1
blink every 0.15 sec,
blink again.
Green LED blinks and
LEDs are constantly on.
Description
Powered and system booting, or network
failed
Power off
Network is disconnected
Connected to network
RED Upgrading firmware
Green Restoring defaults
RED Status after a reset (network connected)
Status after a reset (network
disconnected)
VIVOTEK
User's Manual - 23