Advertisement
For junction box mounting (wet or damp location units) – Remove large center knockout for
(1):
wiring access and remove necessary mounting knockouts. Fasten backplate to junction box using two
#8-32x1-1/4" screws supplied. For wet location units, ensure that the gasket is evenly compressed
around perimeter.
For installation using surface conduit (damp location units only) – Remove necessary mounting
knockouts and secure conduit to flange provided at top of backplate. Mount backplate to wall using
mounting hardware supplied by others.
Connect AC Harness found in electronics module to AC supply. Refer to hookup instructions below:
(2):
If battery heater option has been ordered, installer must finish wiring heater according to
installation voltage. All connections are to be made inside electronics module.
Philips Lighting North America Corporation
200 Franklin Square Drive
Somerset, NJ 08873, USA
Phone: 855-486-2216
www.philips.com/luminaires
Installation
Philips Lighting Canada Ltd.
281 Hillmount Road,
Markham, ON, Canada L6C 2S3
Phone: 800-668-9008
www.philips.com/luminaires
9140052682 February 2016
Advertisement
