Table of Contents
Advertisement
About Audio Cables
The connections between the QuadraSynth Plus and your studio are your
music's lifeline, so use only high quality cables. These should be low-capacitance
shielded cables with a stranded (not solid) internal conductor and a low-
resistance shield. Although quality cables cost more, they do make a difference.
Route cables to the QuadraSynth Plus correctly by observing the following
precautions:
•
•
such as transformers, monitors, computers, etc.
•
may not cause immediate damage, but it can compress the insulation between
the center conductor and shield (degrading performance) or reduce the cable's
reliability.
•
•
firmly grasping the body of the plug and pulling directly outward.
•
as Tweek and Cramolin, when applied to electrical connectors, are claimed to
improve the electrical contact between connectors.
Basic Audio Hookup
J
When connecting audio cables and/or turning power on and off, make sure that all
devices in your system are turned off and the volume controls are turned down.
Because the QuadraSynth Plus includes extensive signal processing as well as a
full complement of sounds, you can make great sounds with nothing more than
an amplifier or a set of headphones.
The QuadraSynth Plus has two Main and two Aux audio outputs. These can
provide an amplification system or mixer with several different audio hookup
options:
•
mono amplification system or individual mixer input.
•
Audio Outputs to a stereo amplification system or two mixer inputs.
•
[MAIN–L] and [MAIN–R] Audio Outputs and two mono cords from the [AUX–
QuadraSynth Plus Piano Reference Manual
Do not bundle audio cables with AC power cords.
Avoid running audio cables near sources of electromagnetic interference
Do not place cables where they can be stepped on. Stepping on a cable
Avoid twisting the cable or having it make sharp, right angle turns.
Never unplug a cable by pulling on the wire itself. Always unplug by
Although Alesis does not endorse any specific product, chemicals such
Mono. Connect a mono cord from the [MAIN–R] Audio Output to a
Stereo. Connect two mono cords from the [MAIN–L] and [MAIN–R]
Dual Stereo/Four Individual Outs. Connect two mono cords from the
Setting Up: Chapter 1
12
Advertisement
Table of Contents
