Alesis QuadraSynth Plus Reference Manual page 174

To send the entire User bank via MIDI:
¿
MIDI In of a device capable of receiving the data (S4, another QuadraSynth Plus,
etc.).
¡
¬
"SEND_ALL TO MIDI."
ƒ
To send a single Program via MIDI:
¿
¡
the User bank (0 to 127) or the Program Edit buffer (EDIT) or any of the 16 Mix
Edit buffers (EDm01 to EDm16).
As this value is changed, the second parameter (destination) will be linked. This is
because most often you will want to transmit a Program to the same Program location.
The only time to do otherwise is when sending to another QuadraSynth Plus (see below).
¬
To send a single Program via MIDI to a different Program number:
¿
¡
the User bank (0 to 127) or the Program Edit buffer (EDIT) or any of the 16 Mix
Edit buffers (EDm01 to EDm16).
As this value is changed, the second parameter (destination) will be linked.
¬
Program to.
If this value is turned all the way up, the "SEND ALL TO MIDI" option will be selected
and the first value will jump all the way up. At this point you will not be able to adjust
the destination value with Quad Knob [2] until you use Quad Knob [1] to re-select the
Program to be transmitted.
The procedure is similar for sending Mixes. Page 4 of the Store function allows
you to send any one of the Mixes.
Similarly, if a Mix is stored, you may want to store each of the Programs used in
the Mix. The "SEND ALL TO MIDI" command in the Program Store function is
an easy shortcut to this.
QuadraSynth Plus Piano Reference Manual
Connect a MIDI cable from the QuadraSynth Plus's MIDI Out to the
Press [STORE].
Use either PAGE [ ] or [ ] to select Page 3 of the Store function.
Turn Quad Knob [1] to the right until the upper right display reads
Press [STORE] to transmit the data out the MIDI Out connector.
Follow steps ¿ through
Use Quad Knob [1] to select a Program. You may select any Program in
Press [STORE] to transmit the data out the MIDI Out connector.
Follow steps ¿ through
Use Quad Knob [1] to select a Program. You may select any Program in
Use Quad Knob [2] to select a Program number to send the selected
Press [STORE] to transmit the data out the MIDI Out connector.
MIDI Transfer and Storage Operations: Chapter 9
¬ in the instructions above.
¬ in the instructions above.
175