Subscribe to Our Youtube Channel
Related Manuals for Foxtech EH640
Summary of Contents for Foxtech EH640
- Page 1 Foxtech EH640 30x Optical Zoom IR Thermal Camera with 3-axis Gimbal User Manual 2020.03 V1.0...
-
Page 2: Note
Please read the instruction manual carefully and strictly follow the requirements of this manual to install and use this product. Foxtech will not bear any legal responsibility for any results or losses caused by improper use, installation, final assembly and modification by users. -
Page 3: Table Of Contents
Foxtech EH640 30x Optical Zoom IR Thermal Camera User Manual Contents Note Disclaimer Intellectual Property Rights System Composition Product System Atlas IDU/IDUS Video Transmission System Ground Station Software Extension Module Installation (with notes) Hardware Installation Software Installation and Configuration Installation and setup methods of third-party videolink... -
Page 4: System Composition
Foxtech EH640 30x Optical Zoom IR Thermal Camera User Manual System Composition Product System Atlas Product Diagram Professional Load IDUS X30, X30T, X30GT Quickly D640, D640C, disassemble, Datalink Software D640A, D640AC gateway, damping 5.8G videolink 2km GCS: R2S 15km video/data link... - Page 5 Foxtech EH640 30x Optical Zoom IR Thermal Camera User Manual Professional load, CAN-SBUS module wiring instructions 7p expansion port 4P network port Serial port 1 Serial port 2 Power supply 12-25V SBUS, professional pod wiring diagram The receiver needs separate power supply, and adapt module need to be powered through the receiver.
-
Page 6: Pod
Foxtech EH640 30x Optical Zoom IR Thermal Camera User Manual Third party network port videolink 7p expansion port(Optional): CAN-SBUS change- over plate or TOPGUN T1/M2 flight control 4P network port Power supply 12-25V Third party videolink and professional pod wiring notices: 1.Make sure the Network segment of pod and third party videolink is consistent. -
Page 7: Video Transmission System
Foxtech EH640 30x Optical Zoom IR Thermal Camera User Manual Interface description: External interfaces on IDU/IDUS include: Power cord :12-25v 4p network port: used to connect computer, video transmission module. 7p extension interface (including serial port, CAN bus interface): only deeply customized and development customer, or the customer using T1, M2 flight control need to use this interface. -
Page 8: Installation (With Notes)
Foxtech EH640 30x Optical Zoom IR Thermal Camera User Manual Installation (with notes) Hardware Installation A. IDU, IDUS installed to drone. Please install the IDU, IDUS to the proper position of the UAV to ensure that the installation position is stable, firm and no sloshing. -
Page 9: Installation And Setup Methods Of Third-Party Videolink
Foxtech EH640 30x Optical Zoom IR Thermal Camera User Manual C. QGC Installation and Installation Refer to corresponding GCS usage instructions D. Mobile app installation and setup Refer to corresponding GCS usage instructions Installation and setup methods of third-party videolink A. - Page 10 Foxtech EH640 30x Optical Zoom IR Thermal Camera User Manual 4. Camera IP modification Open any browser, enter 192.168.42.108 After entering the following interface, username, password are admin Confirmation 2020 FOXTECH All Rights Reserved ©...
- Page 11 Foxtech EH640 30x Optical Zoom IR Thermal Camera User Manual Then the following password modification interface appears, click cancel Do not modify the password, otherwise the software will not working properly. After entering the setup interface, click Settings Network Settings General Settings Change the IP address and default gateway “42”...
- Page 12 Foxtech EH640 30x Optical Zoom IR Thermal Camera User Manual 5. Pod net segment setup complete. Change the network segment settings in the computer TCPIPV4 to the normal network segment. (Different videolink requires different settings, the equipment used shall prevail.) Pod RTSP Common Address: Main stream rtsp ://admin: admin @<...
-
Page 13: Gcs Software Usage Instructions
Foxtech EH640 30x Optical Zoom IR Thermal Camera User Manual GCS Software Usage Instructions Setting area Interface shifting photo One key downward One key forward Yaw following Manual focus+ Auto focus Manual focus- Target following Camera setting Connection A. Preparation. - Page 14 Foxtech EH640 30x Optical Zoom IR Thermal Camera User Manual Tablet (or touch screen) mouse, virtual button operation: 1. Yaw, Pitch adjustment Hold down the left button of the mouse (slides on the screen if using the touch screen) and move up and down in the interface.
-
Page 15: Operating Pods
Foxtech EH640 30x Optical Zoom IR Thermal Camera User Manual Operating Pods gcs support remote real-time download of camera side video, photos. 1. Operational steps view → download interface (as shown below) can download video (MP4 style), photo (jpg) offline. And the photos support real-time preview. -
Page 16: Frequently Asked Questions
Foxtech EH640 30x Optical Zoom IR Thermal Camera User Manual Frequently Asked Questions No Image Hardware checking: pod power supply is normal, pod and idu module are properly connected. The pod works properly. Datalink (sky end, ground end) power supply is normal. The datalink sky end is properly connected to the IDU module, and the connection wire is not broken.
Need help?
Do you have a question about the EH640 and is the answer not in the manual?
Questions and answers