Installing Dm Pro Module And Attaching Cables; Install Sound Module; Label Cables; Connect Dm Pro Module And Trigger Pads - Alesis DM Pro Kit Setup Manual

Prepare and Position Kick Drum Trigger
J
Make sure your kickdrum pedal accepts an inverted beater
a) Place Kick Drum Trigger Block behind pedal. Attach your pedal's clamp to the metal
L-Bracket on the Trigger Block, as you would attach it to the rim of your bass drum.
b) Locate Inverted Beater that comes
with your DM Pro Kit and attach it
to your favorite kick drum pedal as
follows: Loosen the beater clamp.
Remove beater. Insert inverted
beater to underside of beater mount.
Tighten beater clamp.
c) Place your Kick Pedal and Trigger
in a comfortable position.
Position Hi-Hat Pedal
Place beneath Hi-Hat Cymbal Pad in a comfortable position.
You have now completed setup of your Rack A s s e m b l y, Pads and Cymbals.
Installing the DM Pro Module and
Attaching Cables
The final steps for setting up the DM Pro Kit involve the DM Pro Sound Module.

Install Sound Module

Open the separate box containing the DM Pro Sound Module, and place the module in the
Rack Mounting Tr a y. Attach it to the tray using the four rack screws and washers that come
attached to the tray.

Label Cables

The DM Pro Kit comes with color-coded labels for all connector cables. These labels will
make it much easier for you to connect your trigger pads to the DM Pro Sound Module.
Attach matching color-coded labels to the smooth plastic cylindrical surface immediately
above the metal jack at both ends of each cable.

Connect DM Pro Module and Trigger Pads

You are now ready to connect your DM Pro Module to the DM Pro Kit Trigger Pads.
J
I t 's important to distinguish the three Stereo Cables from the six Mono
Cables. The cables can be identified by looking at their 1/4" plug. Mono
Cables have a two-conductor plug, with separate Tip and Sleeve sections.
See Fig. 3. Stereo Cables can be identified by their three-conductor plug,
with separate Tip, Ring and Sleeve (TRS) sections. See Fig. 4
10 DM Pro Kit Setup Guide