Low/Floor To M; Hi-Hat Cymbal - Alesis DM Pro Kit Setup Manual

Attach Low/Floor Tom
a) Choose a Hardware Clamp and loosen large wing nut until clamp's large opening
releases. Attach clamp to far right end of Right Side Tu b e. Make sure that the
c l a m p 's large wing nut is facing you. Tighten large wing nut.
b) Loosen small wing nut and hex nut on Hardware Clamp.
c) Identify Tom Arm and attach it to Right
Side Tube by inserting its open tube end
into the Hardware Clamp. Evenly tighten
the hex nut and wing nut, providing equal
pressure on both sides of Tom A r m .
d) Attach Tom Pad to Tom Arm by inserting
Tom A r m 's splined L-Mount into Tom
Pad. Loosely tighten with drum key.
e) Position Tom Pad at a comfortable height
and angle. Firmly tighten all wing nuts
and drum key bolts.
Attach Hi-Hat Cymbal
a) Identify Hi-Hat Cymbal Pad and attach it
to Tom Arm by inserting open tube end of Tom Arm into the underside of Hi-Hat
Cymbal Pad.
b) Firmly tighten Hi-Hat Pad's wing nut and drum key bolt.
c) Choose a Hardware Clamp and loosen large wing nut until clamp's large opening
releases. Attach clamp to far left end of Left Side Tube (you'll need to leave plenty
of room for Crash Cymbal) next to memory lock. Make sure that the clamp's large
wing nut is facing you. Tighten large wing nut.
d ) Loosen small wing nut and hex nut on Hardware Clamp until small opening is released.
e) Attach Hi-Hat to Left Side Tube by inserting arm into the smaller opening of the
Hardware Clamp. Close the clamp and evenly tighten the hex nut and wing nut,
providing equal pressure on both sides of Tom Arm. Be sure to place clamp around
main section of Tom Arm, avoiding the tapered section at the end of the A r m .
f) Position Hi-Hat Pad at a comfortable height and angle. Firmly tighten all wing nuts
and drum key bolts.
g) Adjust hi-hat's memory lock (this is the memory lock at the far left end of the Left
Side Tube) by loosening drum key bolt and sliding it into the Hi-Hat's Hardware
Clamp. Make sure you align the memory lock's notch with the indentation in the clamp.
h) Firmly tighten the memory lock's drum key bolt.
Attach Crash Cymbal
a) Choose a Hardware Clamp and loosen large wing nut until clamp's large opening
releases. Attach clamp to far right end of Left Side Tu b e. Make sure that the clamp's
l a rge wing nut is facing you. Tighten large wing nut.
b) Loosen small wing nut and hex nut on Hardware Clamp until small opening is released.
c) Identify Cymbal Boom and attach to Hardware Clamp by inserting arm into the
smaller opening of the Hardware Clamp. Close the clamp and evenly tighten the hex
nut and wing nut, providing equal pressure on both sides of Cymbal Boom.
8 DM Pro Kit Setup Guide