4.1.
ADJUSTING THE FIT OF THE HELMET (SEE FIG.1)
4.1.1.
The circumference of the headband is adjusted by turning the wheel on the rear.
4.1.2.
The two top straps can also be adjusted by releasing the pin from the top strap and adjusting as required.
4.1.3.
The distance between the headband assembly and the helmet can be adjusted by undoing the external thumbwheels both sides
and sliding the headband assembly forwards or backwards, as required. Re-tighten the thumbwheels. (See figs.1 and 2.)
4.1.4.
Test the fit of the helmet by lifting it up and closing it a few times whilst wearing it. If the headband moves whilst tilting, readjust it
until it is stable.
4.2.
ADJUSTING THE HELMET TILT (SEE FIG.3)
4.2.1.
If the visor is too low when the helmet is in the lowered position, adjust the tilt of the helmet in relation to the headband.
4.2.2.
Referring to fig.2, loosen the external thumbwheels and lift the tab up to move it to make the helmet tilt up further or to tilt down
further. Then re-tighten the external thumbwheels.
fig.2
5. MAINTENANCE
5.1.
CHANGING THE VISOR
5.1.1.
Release the stud from the body of the brow guard (fig.4).
5.1.2.
Release the two clips from under the vent (fig.5).
5.1.3.
The visor will swivel on the two visor pegs and can be gently pulled free from the body of the brow guard (fig.6).
5.1.4.
To install the new visor reverse the above process.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice. Please note that other versions of this product are available. If you require documentation for alternative versions, please email or call
our technical team on technical@sealey.co.uk or 01284 757505.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
fig.3
fig.4
01284 703534
Original Language Version
fig.5
sales@sealey.co.uk
fig.6
www.sealey.co.uk
SSP78.V2 Issue 1 30/04/2020
Need help?
Do you have a question about the WORKSAFE SSP78.V2 and is the answer not in the manual?