Bosch Rexroth IndraControl L45 Project Planning Manual page 44

42/81 Bosch Rexroth AG
Connections and Interfaces
Rated output current:
- Nominal value
- Maximum value acc. to DIN EN 61131-2
- Signal 1
- Signal 0 (leakage current)
UL rating
- General purpose
- Tungsten
Maximum total current of outputs
Parallel connection of outputs
Output delay time
Contactor size (at 1 Hz)
Lamp load (at 8 Hz)
Switching frequency
● With ohmic load
● With inductive load
Overload protection:
● Typical current level,
switch-off
● Minimum current level, causing
switch-off
● Automatic restart with reduced load
Display overload
Voltage reduced on circuit interruption
in the nominal operating mode
Reverse voltage protection
Supply voltage according to EN 61131-2
Open-circuit power consumption from US Typ. 50 mA
Cable length (unshielded)
Fig.7-17: Data of digital outputs
The output terminals are provided with LEDs that display the respective state
of the outputs.
LED 1, 2, 3, 4 Meaning
Off The assigned output is not set.
Yellow The assigned output is set
Fig.7-18: Status LEDs of digital outputs
An additional two-color LED (identified by D) emits green light in case the 24 V
voltage is present and red light in case of a short-circuit or overload.
DOK-CONTRL-ICL45L65L85-PR01-EN-P
Rexroth IndraControl L45/L65/L85 Control
0.5 A
<= 0.6 A
2 mA ... 0.6 A
<= 0.5 mA
0.5 A
5 W
2 A
Yes, but only within one terminal
< 500 µs
SG1 (6.2 W)
5 W
100 Hz
Function (contactor)
causing 1.2 A
0.6 A
After approx. 10 ms
Red collective LED for all
8 outputs
Electronically limited to (V
Typ. 26 V
Ensured without connected load
DC 24 V
< 100 m
– 50 V)
ext