Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for PORSCHE DESIGN PDB70/00
Summary of Contents for PORSCHE DESIGN PDB70/00
- Page 1 PDB70/00 Soundbar speaker with built-in subwoofer User manual...
-
Page 2: Table Of Contents
Contents 1 Important 4 Use your Soundbar Safety Turn ON and OFF Care for your product Automatically wake up Care of the environment Auto Standby Compliance Select Modes What’s in the Box Adjust the Volume Surround sound mode. 2 Your Soundbar Factory Reset Main unit Setup Menu... -
Page 3: Important
1 Important • Never insert objects into the ventilation slots or other openings on the product. • Where the mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily Read and understand all instructions before you operable. -
Page 4: Care For Your Product
Risk of overheating! Care of the environment • Never install this product in a confined space. Always leave a space of at least four Disposal of your old product and battery inches around the product for ventilation. Ensure curtains or other objects never cover the ventilation slots on the product. -
Page 5: Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: FCC INFORMATION (1) this device may not cause harmful interference, and Warning: (2) this device must accept any • This equipment should be installed and interference received, including operated with minimum distance 20cm interference that may cause undesired... -
Page 6: What's In The Box
2 Your Soundbar What’s in the Box Check and identify the items in the package: • Soundbar Main unit • Remote Control ( AAA Batteries x 2 ) This section includes an overview of the main • Power Cord * unit. -
Page 7: Connectors
Wi-Fi LED indicator (Yellow) Remote control LED State Status This section includes an overview of the remote Blink Wi-Fi AP mode control. Double blink WPS is active Constant on Connected / Pairing successful Connectors This section includes an overview of the connectors available on your Soundbar. -
Page 8: Prepare The Remote Control
(Play/Pause) Replace the Remote Control Battery Start, pause or resume play in USB/BT mode. Press and slide down from the receiver Confirm a selection. side on the back cover to open the battery • , , , (Cursors) compartment of the remote control. •... -
Page 9: Placement
• Do not mix new batteries with old ones. b. Place the whispering wall on the TV rack • Never recharge a battery unless it is If your TV has a base (such as Philips Porsche confirmed to be a rechargeable type. Design TV 70PD9000 TV), you can place the whispering gallery on the TV base. -
Page 10: Connect
Suggested wall mounting height 3 Connect You are recommended to install the TV first before wall mounting the soundbar. With a TV preinstalled, wall mount the soundbar 50mm/2.0’’ in distance from the bottom of the This section helps you connect your Soundbar to a TV and other devices, and then set it up. -
Page 11: Connect To Hdmi Socket
Note Note • • The full Dolby Atmos experience is only available when Your TV must support the HDMI-CEC and ARC the Soundbar is connected to the source via a HDMI function. HDMI-CEC and ARC must be set to On. •... -
Page 12: Connect To Power
Using an optical cable, connect the Before you start OPTICAL connector on your Soundbar to • Make the necessary connections described the OPTICAL OUT connector on the TV or in the quick start guide and the user other device. manual. •... -
Page 13: Select Modes
• To switch the unit off completely, remove • To restore the sound, press Mute again the mains plug from the mains socket. or press Vol+/Vol- (Volume). • Please turn the unit off completely to save Adjust the Subwoofer’s Volume energy when not in use. -
Page 14: Play-Fi (Wi-Fi) Operation
• Set the audio delay, provided only for the Display Description current playback mode. (As provided in Select Equalizer (EQ) Effect the HDMI ARC audio delay mode, the delay Adjust the Bass Level mode is valid only for the HDMI ARC). Adjust the TREBLE Level »... -
Page 15: Bluetooth Operation
Set up the Soundbar with Play-Fi app on Bluetooth, search for and select » The wifi light on the top panel is Porsche Design PDB70 to start changed to solid when the connection connection (see the user manual of is successful. -
Page 16: Optical / Hdmi Operation
• If your Bluetooth device supports AVRCP profile, on the remote control you can press / to skip to a track, • While in OPTICAL/HDMI ARC mode, if there’s no sound output from the unit and the status Indicator flashes, or press to pause/resume play. -
Page 17: Product Specifications
Main Unit Button Action Start, pause or resume play. • Power Supply: 100-240V~ 50/60Hz • MAX Output Power by speaker: Skip to the previous or next track. 120W (RMS) • Power Consumption: 30 W • Standby Consumption: < 0.5 W Tips •... -
Page 18: Troubleshooting
• When the playback freezes and there is 7 Troubleshooting no sound in Wi-Fi mode, please check whether your home network is normal. Remote control does not work Warning • • Before you press any playback control Risk of electric shock. Never remove the casing of the product. - Page 19 For DTS patents, see http://patents.dts.com. Manufactured under license from DTS, Inc. (for companies headquartered in the U.S./Japan/Taiwan) or under license from DTS Licensing Limited (for all other companies). DTS, Play-Fi, and the DTS Play-Fi logo are registered trademarks or trademarks of DTS, Inc.
Need help?
Do you have a question about the PDB70/00 and is the answer not in the manual?
Questions and answers