Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Hochiki ALN-V
Summary of Contents for Hochiki ALN-V
- Page 1 Technical Bulletin Analog 2 JULY 2016...
-
Page 2: Sensor Specifications
These instructions apply to all sensors listed on this Technical Bulletin for maintaining, cleaning and testing. Failure to following these instructions may result in the failure of the sensors to initiate an alarm condition. Hochiki America Corporation is not responsible for sensors that have been improperly maintained, cleaned or tested. -
Page 3: Placement Of Sensors
Use a air flow meter to determine the movement of the air within a structure. Field testing equipment is available from Hochiki America for testing the function of the sensors. -
Page 4: Bottom View
BOTTOM VIEW Manual Cleaning Procedures OUTER COVER This section explains how to clean the ALN-V, ACC-V, and ACD-V RECESS AND KEY sensors. OUTER Tools needed: COVER Hochiki America's cover removal tool (CRT) Small soft bristled paint brush Denatured alcohol Compressed air duster NOTE: Use only lint-free materials when cleaning the chambers of the photoelectric smoke sensor. -
Page 5: Cover Removal Procedures
Cover Removal Procedures This section explains how to remove the outer cover from the ALN-V, ATJ-EA, ACC-V, and ACD-V sensors by using the cover removal tool (CRT). Tools needed: Hochiki America's cover removal tool (CRT) Remove & Disassemble the Sensor: Place the sensor to be disassembled on the CRT as shown Push the CRT. - Page 6 CO cooling phase wait until standby mode status before continuing to test CO The Hochiki ACD-V is a Multi Criteria Sensor. The ACD-V is capable of Smoke, Heat and CO Detection individually along with many criteria combinations based upon the activation mode setting of the detector (the activation mode is set through panel programming).
- Page 7 Programmer Operating Procedure This section explains how to program the sensor's address using the TCH-B100 and TCH-B255 hand held programmer. The hand held programmer is designed for use with Hochiki's DCP protocol supported SLC devices. Features: Remote Programming TCH-B100/-B255 is a compact design and easy to use...
- Page 8 Programmer Operating Procedure This section explains how to program the sensor's address using the TCH-B100 and TCH-B255 hand held programmer. The hand held programmer is designed for use with Hochiki's DCP protocol supported SLC devices. Features: Remote Programming TCH-B100/-B255 is a compact design and easy to use...