Registering Magic Remote Control
How to register the Magic Remote Control
To use the Magic Remote, first pair it with your TV.
1 Put batteries into the Magic Remote and turn the TV on.
2 Point the Magic Remote at your TV and press the
Wheel (OK) on the remote control.
* If the TV fails to register the Magic Remote, try again after turning the TV off and back on.
How to deregister the Magic Remote Control
(Home) buttons at the same time, for five seconds, to unpair the Magic Remote with your TV.
* Press and hold the
(Q.Settings) buttons for more than 5 seconds to disconnect and re-register the Magic Remote at the
• It is recommended that an Access Point (AP) be located more than 0.2 m (0.65 ft) away from the TV. If the AP is installed closer than 0.2
m (0.65 ft), the Magic remote control may not perform as expected due to frequency interference.