Table of Contents
Advertisement
Genesis Ultrasonic Generator-IM-1.1
3.3.3
Bulkhead Immersible and Generator
Follow instruction below to operate bulkhead immersible and generator:
No.
Place the immersible in the tank or container with the 3/4" diameter
mounting stud in the appropriate hole or holes in the tank wall. The
1
diameter of these holes should be 7/8".
By use of the hardware provided, make the connection liquid-tight.
Mount or place the junction box so that liquid from the tank will not
spill on the box. If two mounting studs are present such as in Type
2
DBB, one stud may not have any wires for it because it is used only
to provide a stable mounting.
Fill the tank or container with enough cleaning solution to
3
completely cover the radiating surface.
Connect the coaxial cable from the junction box to the generator
4
module.
Follow steps for degassing and processing parts as described in
5
Section 3.3.1.
6
Check and re-tighten lock nuts periodically.
Rev 1.1, February 21, 2013
Description
3-4
Operating Instructions
Advertisement
Table of Contents
