MINN KOTA PowerDrive i-Pilot Upgrade Installation

Item /
Part # Description
Assembly
2774063 i-PILOT CONTROLLER 1.6 PWRDRV
1
2774054 i-PILOT CONTROLLER 1.6 RT PD
2 2994075 REMOTE ASY, iPILOT 1.6
3 22224704 INSERT-PLUG, BLK,I PILOT
4 2375403 HEATSHRK .375X2 ADH LINED
5 2390800 LANYARD w/CARABINEER, IP REMOTE
n
2397101 MANUAL, QUICK REF, iPILOT 1.6 (not shown)

TOOLS AND RESOURCES REQUIRED

• #2 Phillips Screwdriver
Always wear safety glasses and gloves. Disconnect all power to the trolling motor before beginning any work or
maintenance. Johnson Outdoors Inc. is not responsible for any damage due to improper rigging or installation. If you do not
have the skills, experience and tools to perform the following maintenance and repairs, we recommend you seek the help of a
Minn Kota Authorized Service Center. A list of Authorized Service Centers can be found at http://www.minnkotamotors.com/
Authorized-Service-Providers/. Or contact our Technical Service Department by email at service@minnkotamotors.com or,
by dialing 800-227-6433.
NOTE: These instructions cover accessory installation only. To download the complete
owner's manual visit https://www.minnkotamotors.com/Accessories.aspx. Scan the QR
code to view Minn Kota Accessories Owner's Manuals Online

REMOVAL

a. Use the #2 Phillips Screwdriver to remove the 4 screws that
secure the control box cover and remove the control box cover
b. If AutoPilot was installed remove all six (6) wires connected to
the AutoPilot Board, then remove the Autopilot Board. Cover
the exposed end of each wire with one of the included heat
shrinks and then use the heat gun to seal the heat shrink onto
the connector end.
c. Remove the Insert Plug. Push from the inside, down on the edge
closest to the coil cord, the plug will "pop" out.
d. Use the #2 Screwdriver to remove both sideplates, then remove
the Center Cover exposing the main control board. If CoPilot is
installed disconnect its plug connection from the main control
board.
©2016 Johnson Outdoors Marine Electronics, Inc.
PowerDrive i-Pilot Upgrade Installation
Qty.
1
1
1
1
10
1
1
• Heat gun
CAUTION
a
c
1
2
5
3
• 30-45 Minutes
b
d
2774055
4
minnkotamotors.com | 1