Advertisement
MFJ-561K
1. Insert the shoulder washer into the hole on the side of the paddle facing
out. Make sure that the shoulder is completely inside the hole and the
washer is flush with the paddle.
2. Next, insert a screw into the hole from the inside out. On the outside of
paddle, place a washer, a solder lug and then a kep nut on the screw.
Be sure to tighten it with the solder lug facing away from the arms of
the paddle, parallel to where the base goes (see Figure 1).
3. Repeat steps 1 and 2 for the other side. Make sure that the solder lugs
are not in contact with the paddle. The washers are provided to insulate
the screw, solder lug and kep nut from the paddle.
Figure 1
Travel Iambic Paddle Kit
Advertisement
