Advertisement
Quick Links
Toyota
10R – 04 5004
speedsignal GmbH
Carl-von-Ossietzky-Straße 3
D- 83043 Bad Aibling
EINBAUANLEITUNG
Installation Guide
Hilux VIII. Gen. (2015-)
nur für Fahrzeuge mit analogem Zündschloss
only for vehicles with analogue ignition lock
Art. Nr.
Phone:
+49 8061 49518 – 0
Fax:
+49 8061 49518 – 10
RunLock
B-339TY01
E-Mail:
info@speedsignal.de
Homepage: www.speedsignal.de
facebook:
facebook.com/speedsignal
Advertisement
Related Manuals for Speedsignal B-339TY01
Summary of Contents for Speedsignal B-339TY01
- Page 1 Installation Guide RunLock Toyota Hilux VIII. Gen. (2015-) nur für Fahrzeuge mit analogem Zündschloss only for vehicles with analogue ignition lock Art. Nr. B-339TY01 10R – 04 5004 speedsignal GmbH Phone: +49 8061 49518 – 0 E-Mail: info@speedsignal.de Carl-von-Ossietzky-Straße 3 Fax: +49 8061 49518 –...
-
Page 2: Scope Of Delivery
The installation of this product should only be carried out by trained specialist personnel and in accordance with this manual. speedsignal GmbH cannot accept any liability for injury to persons or damage to property from errors or mistakes in this operating manual. - Page 3 Connect the grey (PIN 3), yellow (PIN 8) and red remove two screws. Disconnect the white plug on (PIN 5) cables of the original cables to the supplied the right side of the steering wheel. cable set, technically correct on the vehicle. B-339TY01...
- Page 4 Abgriffpunkt befindet sich hinter den Abdeckungen. Masse des gelieferten Kabelsatz an Karosserie an- Erreichbar durch den Fahrerfußraum. bringen The tap point is located behind the covers. Attach the ground of the supplied cable set to the Accessible through the driver's footwell. bodywork. B-339TY01...
- Page 5 - Tap point E - Start-Stop button PIN 8 Originales Lila Kabel (PIN 8) mit dem gelieferten Kabelsatz, technisch einwandfrei, am Fahrzeug verbinden. Connect the original purple cable (PIN 8) with the supplied cable set, technically correct, to the vehicle. B-339TY01...
- Page 6 12mm Durchmesser anbringen. Diese Öffnung muss gegebenenfalls gebohrt werden. The RunLock button 6003131 can be installed on a free button. To do this, place the button in an opening with a diameter of 12 mm. This opening must be drilled if necessary. Ø 12mm TX 20 B-339TY01...
-
Page 7: Functional Test
The engine will shut off if you touch the pedals before you deactivate the RunLock and/or insert key to ignition switch to posi- tion II. Illumination and flashing behaviour of RunLock button: button flashes: All conditions for activating the RunLock are fulfilled. button illuminates constantly: RunLock is activated successfully button does not illuminate: RunLock is deactivated successfully B-339TY01... - Page 8 GmbH guarantees within the legal deadline of 2 years from the original date of purchase that this product is free from defects in material and workmanship as long as this product was installed similar to our installation guide.