TDBFXEB INSTALLATION IMPORTANT: Galvin Engineering products must be installed in accordance with these installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical supply conditions must also comply to the applicable national and/or state standards. Failing to comply with these provisions shall void the product warranty and may affect the performance of the product.
Product Installation Guideline 3. Fit the Touch Button 4. Connect the Touch Button to the Controller - Fit the touch button and coloured washer into the Connect the controller to the Solenoid pre-drilled hole. and the battery pack. NOTE: Ensure the o-ring is between the button and the coloured washer.
Page 4
Product Installation Guideline SET 24/48/72 Hour Automatic Flush Press button 6x 1. Press button 6x 2. Wait 5 Seconds 3. Turn water ON then OFF 5. Wait 5 secs 7. Times for desired auto flush 8 After required flow duration 6.
WARRANTY The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied. Galvin Engineering Pty. Ltd.