Advertisement
IQS243 GUI USER MANUAL ......................................................................................................................................... 1
TABLE OF CONTENTS .................................................................................................................................................. 1
1
INTRODUCTION ............................................................................................................................................. 1
2
Setup ........................................................................................................................................................... 1
3
Gui Operation ............................................................................................................................................ 2
1 Introduction
This
user
manual
operation of the IQS243 Graphical User
Interface software.
platform for
rapid prototyping by enabling
application and development engineers to
visualise the real time data stream from the
IQS243 Proximity and Touch Sensor.
2 Setup
The IQS243 Software GUI can be downloaded from the following link:
http://www.azoteq.com/images/stories/software/azoteq_iqs243_setup.zip
Plug in the IQS243 module into the IQS243EV02 Mainboard or wire into specific application
Connect the Mainboard to the Azoteq CTxxx or DSxxxDataStreamer
Run the IQS243 Software GUI
The GUI display is illustrated in Figure 2.1. The "Hints and Tips" Pop-up window in the centre of
the screen contains important information relevant to the software GUI and IC, please take the
time to read though all of the information. The scroll buttons can be used to flip through the hints
and tips and are marked in Figure 2.1.
After closing the Hints & Tips window in the centre of the screen, data streaming can be started
by clicking on the "Start" button, as also depicted in Figure 2.1
Copyright © Azoteq (Pty) Ltd 2012.
All Rights Reserved.
IQ Switch
ProxSens
IQS243 GUI User Manual
®
IQ Switch
Table of Contents
describes
the
basic
The GUI provides a
®
®
Series
®
- ProxSense
Series
.
IQS243 GUI User Manual
Revision 1.0
Page 1 of 5
June 2012
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Azoteq IQ Switch ProxSens Series
Summary of Contents for Azoteq IQ Switch ProxSens Series
- Page 1 Plug in the IQS243 module into the IQS243EV02 Mainboard or wire into specific application Connect the Mainboard to the Azoteq CTxxx or DSxxxDataStreamer Run the IQS243 Software GUI The GUI display is illustrated in Figure 2.1. The “Hints and Tips” Pop-up window in the centre of the screen contains important information relevant to the software GUI and IC, please take the time to read though all of the information.
- Page 2 Please note the “Event Mode” settings on the right hand side of the IQS243 GUI. When the IQS243 IC is configured in Event Mode, communication will only commence when the IC registers Copyright © Azoteq (Pty) Ltd 2012. IQS243 GUI User Manual Page 2 of 5 All Rights Reserved.
- Page 3 Proximity and Touch events are indicated in the GUI, by the channel light underneath the corresponding bar graph. A blue light indicates proximity detection, whilst a red light indicates touch detection, as illustrated in Figure 3.3. Copyright © Azoteq (Pty) Ltd 2012. IQS243 GUI User Manual Page 3 of 5 All Rights Reserved.
- Page 4 Each channel’s visibility and colour can be adjusted along with the scale of the scope view, in the scope view settings section, on the right hand side of the scope view window. Copyright © Azoteq (Pty) Ltd 2012. IQS243 GUI User Manual Page 4 of 5 All Rights Reserved.
- Page 5 Azoteq. The information in this Datasheet is believed to be accurate at the time of publication. Azoteq assumes no liability arising from the use of the information or the product. The applications mentioned herein are used solely for the purpose ofillustration and Azoteq makes no warranty...
Need help?
Do you have a question about the IQ Switch ProxSens Series and is the answer not in the manual?
Questions and answers