Toyota JAT710 Installation Manual page 128

4. APPENDIX
[ 4 ] Time Chart
The time chart is shown below.
• Please contact us when connecting our JAT610 or LW600.
• Contact the respective loom manufacturer when connecting the loom of other make.
Loom running state
Production pulse
(1 pick output)
Stop signal
Stop cause signal
*1. Ta: Loom stop output delay time = 50 msec max.
[ 5 ] Checking Connection between Loom and LTB3
• 12-VDC power supply is mandatory
• Production pulse and run/stop signals are mandatory.
• If no other signal exists, LTB3 counts it as "other stop".
• Check if the signal I/F circuit on the LTB3 side is suitable for LTB3.
• Contact us when connecting our JAT610 or LW600.
• Consult with the loom manufacturer when connecting a loom of other make.
128
*1