Advertisement
B B Connection
B B
B
Note
Do not plug in the AC power cords of both TS-W150 and the
epuipment to the AC power outlets before all other connections
are made.
Preparations
Turn off the power of the equipment and remove the speaker
cords from the speaker terminals on the equipment.
1 Connect the speaker terminals on E the
equipment to the INPUT 2 (FROM SPEAKERS
OUT) terminals on S TS-W150 with C the
supplied speaker cords.
• Make sure the L and R and the ) and (cords
are connected correctly.
2 With the speaker cords removed from the
equipment (see "Preparations" above), connect
R the right and L left speakers to the SPEAKERS
OUT terminals on STS-W150.
3 Set the INPUT SELECT switch to "2".
4 Connect the AC power cord to an AC outlet.
Note
Use left/right speakers whose impedance corresponds with
the value specified on the equipment.
Dynamic Bass System
The TS-W150 adopts a Dynamic Bass System in which port
(1), and air cavity (2) compose an acoustic bandpass filter in
front of air cavity (1). By virtue of this structure, the bass
reproduction limit is extended and sounds higher than middle
range frequencies are reduced in the Dynamic Bass System.
This makes it possible for the TS-W150 to reproduce powerful
bass sound.
En
5
Advertisement
