Before commissioning, always check whether the unit or assembly is suitable for the desired
•
application. In case of any uncertainties or queries, please contact a specialist.
Product description
Portable
•
No external power supply required
•
Tests can be completed in a short time
•
Impact resistant
•
No annual calibration required
•
Copper-plated high performance terminal blocks
•
Ventilated
•
With this device the performance of a 6V or 12V battery or accumulators can be measured. The de-
vice measures the battery voltage at a current flow of approx. 100 amperes.
The voltage of a "good" and fully charged battery remains relatively constant under load. On the other
hand, with a "bad" battery, the voltage collapses quickly. The measurement results are displayed by a
precise analogue measuring unit, whose scale is designed for different battery sizes and types.
Operating the Tester
Warning!
When handling lead-acid batteries, highly explosive detonating gas may be produced. This oxyhydro-
gen gas can be ignited by a spark, cigarette or open flame, causing the battery or accumulator to
burst. This causes the sulphuric acid inside to be sprayed and can lead to severe burns.
Therefore, always wear protective goggles when handling lead-acid batteries. Avoid contact of the bat-
tery with skin and clothing and wear rubber gloves. Do not smoke in the immediate vicinity of the bat-
tery and avoid naked flames. Ensure adequate ventilation.
Discharged lead-acid batteries freeze at extremely low temperatures. Never check a frozen lead-acid
battery! Never place the tester or tools on the battery! Never test a lead-acid battery for longer than 10
minutes!
In the event of eye contact with acid, immediately rinse the eyes with clear water for at least 5 minutes
and seek medical attention immediately! Under no circumstances use medication or eye drops without
doctor's instructions.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Artikel 62553
Seite 4
11 2020-1