Av System; Repair - Stihl FC 75 Service Manual

1
2
3
: Fit the pawl (1) in the hole in the
carrier.
: The long leg (2) of the torsion
spring must locate against the
carrier and the short leg (3)
against the pawl.
– Screw the carrier onto the
crankshaft and tighten it down
firmly, b 3.2
– Install the rewind starter,
b 6.2
– Remove the locking strip.
– Install the spark plug and tighten
it down firmly, b 3.2
Assemble all other parts in the
reverse sequence.
FC 75, FC 85, FH 75, FS 75, FS 80, FS 85, HL 75, KM 85, KW 85
7.

AV System

7.1

Repair

On these units the anti-vibration
connection between the engine and
drive shaft consists of a vibration-
damping rubber element installed in
the fan housing.
Removing
– Remove the shroud, b 5.1
: On machines with a bike handle,
take out the screw (arrow).
– Pull off the control handle.
: Take the throttle cable's
protective tube out of the retainer.
: On machines with a loop handle,
loosen the clamp screws
(arrows) on the control handle.
: On early machines with a loop
handle, loosen the clamp screws
(arrows) on the control handle.
1
2
: Remove the fixing screw (1) from
the AV sleeve.
: Loosen the clamp screw (2).
– Pull out the drive tube.
23