DEMA ATLAS 844P Series Manual page 17

™
DEMA ATLAS 844P SERIES
LAUNDRY CONTROL
Return Policy
No merchandise may be returned for credit without DEMA Engineering Company's written permission.
Return Merchandise Authorization (RMA) number required in advance of return.
Warranty
DEMA products are warranted against defective material and workmanship under normal use and service
for one year from the date of manufacture. This limited warranty does not apply to products that have a
normal life shorter than one year or failure and damage caused by chemicals, corrosion, improper voltage
supply, physical abuse or misapplication. Rubber and synthetic parts such as "O"-rings, diaphragms,
squeeze-tubes and gaskets are considered expendable and are not covered under warranty. This warranty
is extended only to the original buyer of DEMA products. If products are altered or repaired without prior
approval of DEMA, this warranty will be void.
Defective units or parts should be returned to the factory with transportation prepaid. If inspection shows
them to be defective, they will be repaired or replaced without charge. F.O.B. factory DEMA assumes no
liability for damages. Return merchandise authorization number to return units for repair or replacement
must be granted in advance of return.
NOTE:
This unit shall be used within the following limits:
For Indoor Use Only!
Max Altitude: 2000 Meters
Environmental Temp: 0 – 50 °C
Installation Category: II
Pollution Degree: II
Disclaimer: The integrity and operational characteristics of this unit are not guaranteed outside
of the above mentioned parameters. Use of this unit outside of these parameters nullifies
warranty.
I-907 Page 17 of 17
Rev. C-33371