Advertisement
3.7.
cable release
3.7.1.
Press mode button to select correct type (ePB).
3.7.2.
Press the function button to select the appropriate ePB operation.
3.7.3.
Press the 'oK' button to activate the cable release function.
3.7.4.
The Function LED will flash to indicate a successful reset.
3.7.5.
If the function is unsuccessful, Mode LED Selection will flash.
Note: For safety reasons we recommend removing the EPB 30A fuse from
the battery junction box.
3.8.
cable reset
3.8.1.
Press mode button to select correct type (ePB).
3.8.2.
Press the function button to select the appropriate ePB operation.
3.8.3.
Press the 'oK' button to activate the cable reset function.
The Function LED will flash to indicate a successful reset.
3.8.4.
If the function is unsuccessful, Mode LED Selection will flash.
Note: For safety reasons we recommend removing the EPB 30A fuse from
the battery junction box.
3.9.
cable unjam
3.9.1.
Press mode button to select correct type (ePB).
3.9.2.
Press the function button to select the appropriate ePB operation.
3.9.3.
start the engine and run at idle.
3.9.4.
Press the 'oK' button to activate the cable unjam function. When the
FunctionLED flashes, turn the ignition off. If the function is unsuccessful,
Mode LED Selection will flash.
note: As part of this process, the clear codes routine is automatically run to
clear any codes within the ePB system.
Note: For safety reasons we recommend removing the EPB 30A fuse from
the battery junction box.
© Jack sealey limited
Original Language Version
VS8624 | Issue 2 01/07/16
Advertisement
