Advertisement
3.4.
electronic Park Brake (ePB) functions:
cable release
cable reset
cable unjam
clear codes
mode selection for electronic Park Brake (ePB) functions.
mode selection for service reset functions.
service led
3.5.
vehicle set-up
3.5.1.
ensure vehicle's ignition is turned off.
3.5.2.
connect the reset service tool to the diagnostic socket on the vehicle, refer to the vehicle owner's manual for it's location.
3.5.3.
turn on the vehicle's ignition.
3.6.
service reset - 24,000km / 15,000 miles / 12 months
or 12,000km / 7,500 miles / 6 months
3.6.1.
Press mode button to select correct type (service).
3.6.2.
Press the function button to select the appropriate service reset.
3.6.3.
Press the 'oK' button to reset the service indicator. the function led's will
flash to indicate a successful reset.
3.6.4.
if the reset is unsuccessful, mode led selection will
flash.
© Jack sealey limited
– releases the cable to allow the Brakes to be changed on the vehicle.
– resets the cable if the emergency release cable has been activated.
– Allows the ePB to be un-jammed when the vehicle has entered a state where the brakes screech when applying
the Parking Brake, the rear brakes squeak or rub when the vehicle is moving, or there is evidence of shoe-drag.
– Allows the clearing of any codes that are, or have been present as a result of the emergency cable being activated
or the Parking Brake becoming jammed.
ePB led
Original Language Version
function selection Button
oK Button
mode selection Button
VS8624 | Issue 2 01/07/16
Advertisement
