Mounting - Champion Eseries HRU Installation/Operation Manual With Service Replacement Parts

NOTE:
The HRU may have been mounted at the factory so the procedures
described below may not be required.
1. Install the HRU after the dishwasher is completely assembled.
2. Lift the unit with a forklift or a minimum of four persons capable
of positioning and lowering the HRU into its final position.
3. Make sure the HRU vent inlet (A) is centered on the dishwasher.
4. Install the mounting hardware installed in the installation kit from the
inside of the dishwasher hood to secure the HRU to the machine
5. The mounting hardware (B) includes: (7) Hex hd. bolts 1/4-20 x 5/8",
(7) 1/4" split lock washers, and (7) 1/4" flat washers.
C L
6. Electrical power is prewired from the heat recovery control box to
the dishwasher main control cabinet to operate the HRU.
Dishwasher Direction of Travel
B
B
A
B
B
B
Top View of the dishwasher unload section.
(HRU shown in gray)
Installation
Installation

Mounting

B
HRU
B
3