Maintenance; Clean Static Mixers; Clean "B" Side Screen; Clean Mix Manifold Outlet - Graco 24M398 Instructions Manual

Xp mix manifold kits
Table of Contents

Advertisement

Maintenance

Maintenance
Follow Pressure Relief Procedure the when you
stop spraying or dispensing and before cleaning,
checking, servicing, or transporting equipment.

Clean Static Mixers

See F
. 1 on page 9. Typically, two static mixer
IG
housings are connected to the mix manifold outlet (H).
These housings use plastic mix elements, available in a
package of 25 (Part No. 248927).
NOTICE
Never use a swivel union on the mixer inlets. The
union will compress the tube and make it
impossible to remove the mix element.
To clean the housing and replace the mix element:
1. Follow the Pressure Relief Procedure on page 21.
2. Remove mixer housings (J) from whip hose (K).
3. Place flats of mixer housing (J) in a vise. Push mix
element (P) out of the inlet end.
4. If necessary, use a 1/2 in. drill bit to drill out old
material and the mix element from the inlet end,
down to the internal shoulder at the outlet end.
5. Use a brush to clean any debris in housing (J).
6. Insert new mix element, wide end first.

Clean "B" Side Screen

The following instructions apply only when using the
strainer accessory for low viscosity fluids. See
Accessories on page 36.
1. Loosen swivels (19) and remove shutoff handle (21)
and valves (20). See F
2. Remove "B" inlet union (19) from manifold block (1).
26
. 7.
IG
3. Pull "V" screen (17) and retainer o-ring (18) straight
up and out with a needle nose pliers.
4. Clean or replace screen (17).
5. Reinstall screen (17) and o-ring (18) with accessory
tool 15T630.
The o-ring (18) is used as a retainer ring, not a seal. It
may be scratched or deformed from pushing the screen
(17) back in.
6. Install "B" inlet union (19) from manifold block (1).

Clean Mix Manifold Outlet

1. Remove outlet fitting (5) to expose "B" center
injection tube (4).
2. Clean any build-up on, around, or inside the tube
(4).
3. Reinstall outlet fitting (5).
End of Product Life
At the end of a product's useful life, recycle it in a
responsible manner.
21
20
19
18
17
4
5
3A0590R

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

262807

Table of Contents