Converting To Remote Mix Manifold; Installing Remote Recirculation Manifold - Graco 24M398 Instructions Manual

Converting to Remote Mix
Manifold
Loosen the swivel fittings of the A and B material inlets
(AA, AB) and remove the standard XP mix manifold
(AD).
For 262522: Use the mounting fasteners (AV) to mount
the standard XP mix manifold (AD) to the remote
carriage. See Mounting without Carriage (page 17) if
not using a remote carriage.
For 24Z934: Remove the existing mounting fasteners
(AV) and discard. Use the long fasteners (BD) (shipped
loose with kit) to install the standard XP mix manifold to
the remote carriage with heater manifold. Refer to your
heated hose manual for heated hose connection
instructions.
3A0590R
Installing Remote Recirculation
Manifold
1. Follow the Converting to Remote Mix Manifold
procedure on page 17.
2. Connect the remote recirculation manifold to the mix
manifold by connecting the "A" fitting end (CK) to A
material inlets (AA) and the "B" fitting end (CL) to B
material inlets (AB).
3. Connect "A" and "B" material hoses to the
recirculation manifold inlet (CA, CB).
4. Connect the recirculation hoses (R, S) of the heated
hose bundle to the corresponding remote
recirculation ports (CR, CS).
NOTE: Not all heated hose bundles include
recirculation hoses.
5. Connect the recirculation hoses (R, S) to the
corresponding return hoses.
Mounting without Carriage
To mount the bare manifold, drill two holes in the
mounting surface, and secure with the two 1/4-20
screws (28).
1.1 in. (27.94 mm)
Installation
9/32 diameter
17