Comar Systems CSB200 Installation And Instruction Manual page 6

CSB200 Class B AIS
INSTALLING THE CSB200 UNIT
Packing List
1 x CSB200 Transponder unit
1 x Power Cable
1 x PC 9pin D Male to Female Programming cable
1 x 9pin D Male Plug with wire ends.
1 x CD
1 x Instruction Manual
WARNING:
Do not connect the CSB200 unit to a mains (line) AC
electrical supply, as an electric shock or fire hazard could result.
CAUTION: Do not connect the CSB200 unit to a DC supply
exceeding 15.6 V or reverse the supply polarity. Damage to the unit
may result.
CAUTION: The CSB200 unit is designed for operation in the
temperature range -25 °C to +55 °C. Do not install (or use) the
CSB200 unit in environments which exceed this range.
CAUTION: The CSB200 unit should be installed in a location where
it is protected from water and spray.
Electrical Connections
Connect a 12V DC supply (9.6-15.6V) capable of supplying 2A peak to
the DC power lead.
Positive = RED Negative = BLACK
The case of the unit is not isolated from the negative terminal of the
supply and therefore it is recommended that the unit is not attached
to metal parts of the vessel.
R4.0 6