Gemini GPK1200 Instruction Manual page 13

No sound or poor sound
Adjust the volume.

Disconnect the headphones.

Check that the speakers are connected correctly.

No response from the speaker
Disconnect and reconnect the AC power plug, then turn on the speaker again.

Remote control does not work
Before you press any function button, first select the correct source with the remote control instead

of the speakert.
Reduce the distance between the remote control and the unit.

Insert the battery with its polarities(+/- signs) aligned as indicated.

Replace the battery.

Aim the remote control directly at the sensor on the front of the speaker.

Connot play from USB device
The formats of these files are not supported.

The USB device is incompatible with the unit. Try another one.

Poor radio reception
Increase the distance between the speaker and your TV.

Full extend the FM antenna.

Put the speaker at a open area to search radio.

FCC Warning
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any inte rference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interferenceto radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
•
connected.
Consult the dealer or an experienced radio/TV technician for help.
•