Aiphone KBW-M Instructions

Video Modulator for the KB Series Color Video System
The KBW-M adaptor converts a standard CCTV camera's signal to a 2-wire signal, compatible with the
KB 3x5 Color Video system. This allows the utilization of a color camera on a video input on the KB
system, viewable from any monitor in the system. (A camera and KBW-M can be added to any input
that is not used by a KB-DAR video door station.)
KBW-M
Output to
KB-3MRD
WIRING DIAGRAM: KBW-M Modulator for Standard CCTV camera
KB-DAR
A1
A2
KB-DAR
A1
A2
CCTV Camera
75 Ohm, 1V Peak-to-peak
(Independently powered)
Motion Detector*
(Optional)
* Or any signaling
device that provides a
normally open
momentary dry closure.
KBW-M
- INSTRUCTIONS -
Camera
input
Input from Motion
Detector
KBW-M
A1
A2
BNC
Cnctr
MD
MD
Motion Detectors with N/O Contacts:
Detection Systems DS720I
Pulnix 6612
Intellisense 8140S
Ademco 1998PI
Sentrol AP750
KBW-M TERMINAL DEFINITIONS:
BNC Connector: Coax input from CCTV camera
A1
A2
MD
MD
KB-3MRD
1A1
Non-Polarized
1A2
2A1
Non-Polarized
2A2
3A1
Non-Polarized
3A2
B1
B2
PS-2420UL
+
+
-
-
2-Wire output to
KB-3MRD
Input from motion detector
(with normally open contacts)
NOTES:
1. In this system example, the CCTV camera
is on input #3. Cameras are viewed by
pressing the MONITOR button (on any
monitor.) Press once to turn on camera 1
(KB-DAR), press again to switch to camera 2
(KB-DAR #2). Pressing MONITOR a third
time will switch to Camera 3 (CCTV), and a
fourth time turns the monitor off.
2. OPTIONAL: An input for a motion detector
is provided to activate the CCTV camera.
The Monitor will turn on and a chime will be
heard. The monitor will stay on for
approximately 30 seconds.
Special
Order
Products
Pg. 1