Connectors - Acconeer XE132 User Manual

Bottom Side:

3.1.7. Connectors

USB (J1)
USB is used as power supply for the XB132 as well as for flashing and communicating over UART.
USB is connected to the Silicon Labs chip CP2105 which converts the UART interfaces from XM132
into USB data signals. The pinout of J1 is shown in Table 2.
Pin Number
1
2
3
4
5
Page 17 of 30
2020-09-25
Table 2. The pinout of J1.
Signal
VBUS
D-
D+
ID (GND)
GND
Entry module EVK hardware user guide
© 2020 by Acconeer – All rights reserved