1200 Series SmartPanels 1.1 User Manual
Firmware update via web interface
Enter the IP address of the AES67 interface (Ethernet connectors)
of the SmartPanel in the web browser of a PC on the same
network.
The IP addresses of the SmartPanel are displayed in the
Panel-Menu > Network
> AES67.
Do not disconnect the SmartPanel from mains during
the update process.
Open the web interface of the SmartPanel:
·
Enter the IP address in the web browser
(e.g. 192.168.41.159).
In this example there is only one SmartPanel in
the network.
The web interface opens.
·
Open on the right side the main menu (
the SmartPanel and select 'Firmware Update'.
The firmware manager opens.
Click on the 'SELECT FW' button.
·
·
Navigate to the location of the firmware file
and select the desired one by clicking the
Open button.
36
figure 48: IP address of the
SmartPanel
figure 49: web interface of the SmartPanel
) of
figure 50: Firmware Update
figure 51: select firmware
·
Click on the 'INSTALL' button.
The selected firmware is transferred into
the SmartPanel. A bar graph visualizes
the update progress.
The SmartPanel must be rebooted to
finish the update process.
·
Click on the 'Reboot' button if the
'Auto Reboot' function is disabled.
The device is restarted. The connection is
interrupted during the restart.
If the connection is re-established after
the reboot, the new firmware version is
active.
figure 52: install
figure 53: install
figure 54: reboot
figure 55: restarting device
figure 56: new firmware