Liteville Rockshox Retrofitting Instructions

Retrofitting a Rockshox Stealth Dropper Post to a Liteville Frame
Use of a RockShox Stealth dropper post with the remote cable exiting from the bottom is possible on some Liteville frames
if a suitable hole is drilled. Note: if this hole is made, the warranty for this area of the frame is void. It should also be noted
that the Liteville crash replacement warranty (owner bears partial replacement cost dependent on age of frame). But before
you go ahead, please read the entire below instructions as they contain some important tips.
Tel. +49 (0)8370 929988 Fax +49 (0)8370 929888 liteville@liteville.de
Syntace GmbH Am Mühlbach 5C D - 87487 Wiggensbach
The hole must be marked in line with the lowest cable
guide and approx. 3mm above the weld.
Before drilling, use a punch to prevent slipping when
drilling.
Now using a 3.5mm drill bit make the first hole.
Then use a 8mm drill bit with very little pressure to
enlarge the hole. The lower edge of the hole should
now ideally overlap with the weld by 1-2mm.
Valid for
Liteville 301 Mk8 to Mk10
•
Liteville 601 Mk1
•
Liteville 901 Mk1 to Mk2
•
14.12.2012