In order for us to help you efficiently in case of an accident (with a repair, a warranty case or a general service) you should register your bike. This way, you also Tire width automatically extend the warranty of your Liteville to 10 years. Hubs X-12 thru axle...
B. USAGE AS INTENDED frames #142213 polish pad works finish frames 1pcs. VarioSpin top cap There is no restrictions for your Liteville H-3 Mk2 1pcs. baseplate cone 1.5 #127159 frame as to the maximum rider weight or the 1pcs. topplate cone 1 1/8 #127166 range of usage of the bike, however you need to 1pcs.
6. Bottom bracket / crankset 7. Drivetrain HUB MEASUREMENT FRONT HUB FRONT HUB The width of the Liteville 4-ONE bottom bracket The Liteville 4-ONE frame can be assembled with shell is 68 mm and is thus compatible with all BSA one- und two-speed drivetrains.
11. Brakes · SKS 35 mm - 20-28 x 622 · SKS 45 mm - 28-35 x 622 The Liteville 4-ONE Mk1 frame can be assembled · SKS 53 mm - 35-42 x 622 14. Headset only with disc brakes.
Please refer to the extra manual of Eightpins that One alternative product: Cane Creek eeNut assembly. In case you face problems during the exemplifies the assembly process with a Liteville assembly, please directly contact Syntace. https://www.eightpins.at/en/service- einbau-ngs2-en/...
4. Handlebar / stem 6. Bottom bracket / crankset / front 7. Shifting cable and brake hose routing derailleur / rear derailleur Mount and adjust the handlebar and stem NOTE: : Mind the clearance between the according to the Syntace manual. Mount the two bottom bracket bearings and the crankset according to the manufacturer’s crank arm and the chain stay as well as...
8. Cable routing rear derailleur The new frame comes with the rear derailleur cable housing laying inside the frame already. In case the shift cable housing needs to be replaced, follow the steps below: NOTE: if you face issues with the assembly, we recommend using the ParkTool kit Internal Cable routing kit’...
9. Brake hose 1. Unscrew the brake hose at the rear brake caliper 4. Slip a foam tube over the hose. 7. Carefully insert the brake hose and push it 10. Push the ParkTool installation tool out of the and remove the capsule and the nut. towards the top end of the down tube until the frame at the rear end.
• Push the cable housing into the right-hand, steering tube. Push the housing into the down The Liteville WorksFinish is a genuine raw Alu- tube and have it exit at the right hand of the bottom hole at the steering tube. Guide the...