Table of Contents
Advertisement
REMOVING ALL BALLS FROM THE SYSTEM
1
REMOVE BALLS FROM TRAY OR BUCKET
First, remove all balls
from the Bucket (545
or 1040+) or Trays
( 2 0 4 0 + ) a n d p l a c e
them in a box where they will
not get mixed in with balls of
the other size. Then disconnect
the Connector Cable from the
back of the robot.
LOOSEN WING NUTS
2
Loosen the two Wing
Nuts that hold your
robot body onto the
Ball Bucket or Center
Tro u g h . R o t a t e t h e
black, rec tangular Clip Washers
180˚.
Clip Washer
3
REMOVE ROBOT BODY
Pull straight up on the
robot body to remove it
from the Ball Bucket or
Center Trough.
4
REMOVE CLEAR FRONT COVER
Place the robot body
on your table. Pull
t h e C l e a r F r o n t
Cover off by squeez-
ing on the circular fingerholds
on the sides of the cover with
your thumb and fore finger,
and then pulling up while squeezing. Pull the cover loose
first at the top and then at the bottom.
5
REMOVE BALLS FROM INSIDE ROBOT
Remove all balls
from inside the
robot and place
in the box with
the other balls of the
same size. Also gather up
any balls that are on the
floor or lying around
loose in the playing area and place them inside the box too.
6
Reattach the Clear Front
Cover (reverse of Step 6).
Reattach the robot body, mak-
ing sure that it fits fully down
on the locating tab of the Center Trough
or Ball Bucket. (See Figure 17, page 13.)
Finally, re-tighten the Wing Nuts
(reverse of Step 4).
7
Place balls of the other size in the Ball Bucket or
Ball Trays. (Be sure to wash and dry new balls
before using them for the first time.) Reconnect
the Connector Cable (see Figure 17, page 13). Turn
power back on and you're ready to play.
11
REATTACH ROBOT BODY
FINAL PROCEDURES
Hide quick links:
Advertisement
Table of Contents
