inventum ST308WZA Instruction Manual page 19

Table of Contents

Advertisement

Available languages

Available languages

• Slide a new dust bag [3] in the dust bag holder.
• Open the cover of the dust bag compartment. The opening of the dust bag is automatically pushed
on the correct location when the cover is being closed. The cover of the dust bag compartment cannot
be closed when the dust bag has not been placed correctly. Place the dust bag once more, in accordance
with the instructions.
CLEANING OR REPLACING THE HEPA FILTER
The HEPA filter cleans the air one more time before it is ejected by the vacuum cleaner. Clean the HEPA filter
at least once every six months or when it is very dusty. When the HEPA filter is damaged, it must be replaced
by a new original filter.
• Press the clip to open the grille [4] under which the HEPA filter is located.
• Push the clip backwards and remove the HEPA filter [5].
• Clean the HEPA filter with lukewarm running water and allow the filter to dry in the air. Do not use cleaning
agents or brushes.
• Only place the HEPA filter back once it is fully dry, or place a new HEPA filter.
• Place back the grille. Make sure it is properly attached.
Attention
• Only use the vacuum cleaner when all filters and a dust bag have been placed. If not, the suction
power could be reduced or the motor could be damaged.
• Remove the plug from the socket before cleaning or replacing the filters.
• Torn or not properly sealing filters could damage the motor. When a filter is defective, it must
be replaced by a new original filter.
• The filters may not be cleaned in the dishwasher.
• Do not use a hair dryer to dry the filters.
STORAGE
The vacuum cleaner can be stored in two ways. Standing on its rear side - parking position - or its bottom side,
so that the appliance takes up less space.
• Rewind the cord by pressing the button for automatic cord rewinding
• Slide the button on the top side of the tube upwards and push the top part of the tube downwards
to shorten the tube. When you let go of the sliding button, the tube will snap tight.
• Slide the floor nozzle in the holder on the bottom side of the vacuum cleaner - parking position - or place the
vacuum cleaner upright and slide the floor nozzle in the holder [6] on the bottom side of the vacuum cleaner.
with your foot.
3
4
5
6
19
English

Advertisement

Table of Contents
loading

Table of Contents