Lucci LEDlux 240780 Installation Instructions

Installation Instructions
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of this product. Please keep instructions for future reference.
Warranty
•
This luminaire is covered by a 3 year warranty. The warranty is from date of purchase, not the date of installation.
•
Warranty will be void if there is any damage due to improper usage or modification to the luminaire.
•
Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void warranty.

Installation requirements

•
Select a suitable location for installation:
- It is only suitable for outdoor use.
- This luminaire is protected against water penetration to IP44 standards, which is water splashing from every
direction. This must be maintained during installation.
- The mounting point must support 2 times the weight of the luminaire.
•
Lay out all the components on a smooth surface and make sure there are no components missing before assembling.
If parts are missing, return the complete product to the place of purchase for inspection or replacement.
•
Check whether the luminaire has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.

Installation directions

Remove all packaging material from the product and be careful not to throw away accessories that may be hidden within
the packaging material.
NOTE: Choose a location which has access to direct sun light. Avoid areas with possible shade on the solar panel.
Install the luminaire following the below steps (Figure I):
1. Remove the screw (S) from the bottom of the base;
Remove the mounting bracket (A) from the luminaire (B);
Install the mounting bracket (A) onto the wall by using the mounting screws. Ensure that the anchors and mounting
screws used are suitable for the mounting surface.
2. Slide the luminaire (B) onto the mounting bracket (A);
3. Secure the luminaire (B) by tighten the screw (S);
4. Adjust the setting of the PIR sensor according to your need. Refer to the 'PIR Sensor Information' section for more
information.
5. Turn the ON/OFF switch to the ON position.
Make any final adjustments to the solar panel and the lamp head according to your need (Figure II).
NOTE: DO NOT rotate over the angles specified in the Figure II, which may damage the internal wires.
NOTE: The solar panel will be more efficiency when facing perpendicular to the sun.
1 | P a g e
HORIZON SOLAR LIGHT WITH SENSOR
SKU# 240780
Rated Voltage 3.7V DC
v 1 . 0 ( 0 3 / 2 0 2 0 )