Installation Instructions
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of the product. Please keep the instructions for future reference.
Warranty
•
This product is covered by a 1 year warranty. Please retain proof of purchase.
•
Warranty will be void if there is any damage due to improper usage or modification to the product.
•
Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void warranty.
Installation requirements
•
Select a suitable location for the luminaire;
-
Ensure it is on a flat and stable surface.
-
This product is suitable for indoor use only.
-
Do not place flammable material near or over the luminaire.
-
Ensure the luminaire is not placed next to any air vents and is not in any moist or damp areas.
•
Take care not to pull any electrical wires during unpacking as this may damage the connection.
•
Lay out all the components on a smooth surface and make sure there are no components missing before
assembling.
If parts are missing, return the complete product to the place of purchase for inspection or replacement.
•
Check whether the luminaire has been damaged during transport. Do not operate/install any product which
appears damaged in any way. Return the complete product to the place of purchase for inspection, repair or
replacement.
Operation directions
Operation:
1. Touch the main switch (4) to activate the luminaire. (Figure 1)
2. Once the luminaire is activated, wave your hand over the luminaire to turn it on and off. (Figure 2)
3. To adjust the brightness, place your hand above the luminaire and move it up and down. (Figure 3)
NOTE: Ensure there is no objects sitting above the luminaire within 25cm.
4. Press the power switch (4) again and the luminaire will turn off.
Batteries and charging:
NOTE: The luminaire includes a re-chargeable Li-Battery.
1. When the charging indicator (1) is blue, the battery is low and will run out within 10-20 minutes.
To charge the luminaire, plug the provided USB cable into the charging port (2) and connect the USB cable to a
power adaptor. The charging indicator will be red when charging and will be off when fully charged. (Time to fully
charge is approximately 3-4 hours).
NOTE: Please ensure an appropriate power adaptor is used for charging according to the rated input (5V DC, 1.5A) of
this luminaire.
1 | P a g e
MOBY LED MOTION SENSOR LAMP
SKU# 250905
Rated Voltage 5V DC, 1.5A
v 1 . 0 ( 0 9 / 2 0 1 9 )
Need help?
Do you have a question about the MOBY and is the answer not in the manual?
Questions and answers