Advertisement
- You can pre-dry your hair with the drying function (B) (without the brush) while still kee-
ping your hair damp.
- Divide your hair into individual sections a few centimetres wide and work on one section at a
time. You can use clips to hold up the other sections of hair.
- Fit the brush (large or small diameter, depending on the length of your hair and the desired
effect) to the body of the appliance, pushing it until it clicks home.
- Choose the speed of rotation (D).
- never use alcohol to clean your appliance,
- never immerse the appliance or brushes in water,
- take care to dry the parts that you have just cleaned,
- from time to time carefully remove any hair left in the brushes.
5. ENVIRONMENT PROTECTION FIRST!
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point.
6. IN THE EVENT OF A PROBLEM
•
"My hair gets tangled":
1. Did you untangle your hair properly?
2. Did you separate the sections well before working on them?
3. You can stop the brush rotation at any time by releasing the control button (C), or by reversing
the direction of rotation. The brush can then be released from the body of the appliance to free
the hair.
•
"The brush is not rotating fast enough!". Try adjusting the speed control "D".
•
"The brush stopped rotating".
1. Remember that your hair must be pre-dried and untangled.
2. Is the section too thick? Work on a smaller section.
•
"My appliance has stopped working". The thermal safety device has tripped.
1. Unplug the appliance.
2. Leave it to cool for about 30 minutes before using it again.
3. If the problem persists, contact the after-sales service.
•
"The bristles of the brush are lying flat". It is important to put the brushes away in the protec-
tors
supplied for this after every use.
- If the bristles were flattened before use, they will straighten naturally during blow drying thanks
to the combination of automatic rotation and hot air.
Bring the brush against the
section of hair: the section
will automatically wind
itself around the brush in a
smooth, continuous move-
ment.
4. CARE
NOTE! Always disconnect the appliance
before cleaning.
Cleaning the appliance and brushes:
- your appliance requires very little care, it
can be cleaned with a dry or slightly damp
cloth,
EN
Advertisement
