Traceable 98766-84 Manual

3. - - – Two dashes indicate the temperature,
although still displayed, is above the range of
the unit.

MOUNTING THE UNIT

1. To allow for different mounting positions, the white
the unit.
2. Select the position and location where the unit will
be mounted.
3. Make sure the surface of the location is clean
and smooth.
4. Attach the unit to the selected location by remov-
ing the paper covering from the adhesive tape on
the back of the unit holder and pressing the unit
5. The unit can be more permanently mounted by
utilizing the two small screw holes on the unit
holder. (Screws are not included.)
BENCH STAND
1. The bench stand is part of the BATTERY
COMPARTMENT DOOR.
2. Locate the small rectangular opening at the bot-
tom of the BATTERY COMPARTMENT DOOR.
3.
4. To close, snap the stand closed.
1.800.561.8187

ALL OPERATIONAL DIFFICULTIES

If this unit does not function properly for any reason,
please replace the batteries with two new AAA
below.) Low battery power can occasionally cause
Replacing the batteries with fresh ones will solve
any AAA alkaline batteries.

BATTERY REPLACEMENT

1. To open battery compartment, slide BATTERY
COMPARTMENT DOOR on the back of unit in
direction of arrow.
2. Remove depleted batteries. Insert two fresh AAA
alkaline batteries in appropriate positions to agree
with the polarity symbols (+ and -) in the battery
compartment.
3. Replace BATTERY COMPARTMENT DOOR.
www.
information@itm.com
.com
TRACEABLE
®
HUMIDITY/
TEMPERATURE
METER WITH
DUAL MIN/MAX
MEMORIES
INSTRUCTIONS