Related Manuals for ElectrIQ QGH604B
Summary of Contents for ElectrIQ QGH604B
- Page 1 USER MANUAL 4 BURNER GAS HOB IQGH604B BLACK GLASS IQGH603S STAINLESS STEEL IQGH604W WHITE GLASS Read these instructions carefully and keep them safe for future reference.
-
Page 2: Table Of Contents
CONTENTS SAFETY UNPACKING AND PARTS INSTALLATION OPERATION ADJUSTMENTS ENERGY SAVING CLEANING AND MAINTENANCE GAS SPECIFICATIONS TECHNICAL SPECIFICATIONS... -
Page 3: Safety
SAFETY PRECAUTIONS Whilst this product is compliant with all safety requirements, incorrect or inappropriate use can lead to both personal injury and potential damage to property. Please read the contents of this instruction booklet thoroughly before fitting or using this appliance. Make sure you keep the manual safe for future reference. -
Page 4: Installation
• Your appliance is produced in accordance with all applicable local and international standards and regulations. • Maintenance and repair work must only be made by authorised service technicians. Installation and repair work that is carried out by unauthorised technicians may endanger you. It is dangerous to alter or modify the specification of this appliance in any way. - Page 5 • Electrical connection for the ignition system for the hob should only be made to connections with an earth system installed in compliance with local regulations. If there are no connections with an earth system in place where the hob will be installed, these must be installed by a qualified electrician.
- Page 6 UNPACKING THE HOB Please take great care when unpacking; a sharp blade should not be used to unpack the appliance, as it may damage the components inside. Components damaged or marked due to careless unpacking are not covered under the guarantee. PARTS LIST Bracket Sponge...
- Page 7 POSITION OF THE HOB NOTE: This appliance is to be built into a kitchen unit or 600mm worktop, providing the following minimum distances are allowed. The edges of the hob must be a minimum distance of 60mm from a side or rear wall. 700mm between the highest point of the hob surface (including the burners) and the...
-
Page 8: Operation
INSTALLING THE HOB • Remove the pan supports, the burner lid and flame spreader. Carefully turn the appliance upside down and place it on a cushioned area to avoid damage. • Take care that the ignition devices and flame supervision devices are not damaged in this operation. - Page 9 GAS CONNECTION • Place the Bracket (B) over the holes that match the length of the screws. There are one set of screw holes in each corner of the hob. • Slightly tighten the screw (C) through the bracket (B) so that the bracket is attached to the hob, but so that you can still adjust its position.
- Page 10 HOW TO USE IQGH604B / IQGH604W IQGH603S • The appliance is fitted with a flame failure safety device on each burner, which is designed to stop the flow of gas to the burner head in the event of the flame going out. •...
-
Page 11: Adjustments
GAS ADJUSTMENT NOTE: This appliance is fitted with a flame failure safety device on each burner which is deigned to stop the flow of gas to the burner head in the event of a flame going out. IMPORTANT: Take precautions when adjustments are carried out converting one gas to another. -
Page 12: Energy Saving
HOB SAFETY AND ENERGY SAVING IMPORTANT: It is not recommended for roasting pans, frying pans or grill stones to be heated at the same time on the hob, the resulting heat build up may damage the appliance. Do not touch the top plate while the hob is in use, or soon after use. Injury may occur. If liquid begins to boil over a pan when cooking, turn down the flame power to allow the liquid to settle and simmer gently. -
Page 13: Cleaning And Maintenance
CLEANING AND MAINTENANCE • Cleaning must only be carried out when the appliance has had sufficient time to cool down. • The appliance should be disconnected from the mains before cleaning. • Clean the appliance regularly, for best results, clean after each use. •... - Page 14 BURNERS • Remove the burner lids and flame spreaders by pulling them upwards and away from the top plate. • Soak them in hot water with a small amount of detergent or washing up liquid. • After cleaning, wipe all parts dry and make sure that the flame holes are clean and completely dry.
-
Page 15: Gas Specifications
GAS CATEGORY, GAS TYPE AND DESITINATION COUNTRY FOR ALL MODELS. GAS SPECIFICATION... -
Page 16: Technical Specifications
RAPID (1) SEMI RAPID (2) AUXILIARY (1) AUXILIARY (1) ΣQn 7.5kW 7.5kW electriQ UK SUPPORT www.electriQ.co.uk/support Call: 0333 043 6692 or complete the online form Office hours: 9AM - 5PM Monday to Friday www.electriQ.co.uk Unit J6, Lowfields Business Park Lowfields Way, Elland... - Page 17 INFORMATION FOR DOMESTIC GAS FIRED HOBS In acc. with regulation (EU) No. 66/2014 Symbol Value Unit Model Identification IQGH603S Type of hob Natural Gas (G20) Number of gas burners Energy efficiency per gas 59.9, 59.2, 58.2 gas burner burner Energy efficiency for the 59.1 gas hob gas hob...