Table of Contents
Advertisement
For the latest online information about Adaptec products and
services, call the Interactive Fax Service 23 hours a day, 7 days a
week, at 408-957-7150.
For technical assistance, call Adaptec's Technical Support Hot
Line at 800-959-SCSI (7274), or 408-945-2550. M–Th: 6:00 a.m.–
5:00 p.m., F: 6:00 a.m.–3:00 p.m., Pacific Time.
To order Adaptec software and SCSI cables, call 800-442-SCSI
(7274), M–F: 6:00 a.m. to 5:00 p.m., Pacific Time. If you are call-
ing from outside the U.S. and Canada, the number is
408-957-SCSI (7274).
To request literature on Adaptec products, call 800-934-2766.
M–F: 5:00 a.m.–6:00 p.m., Pacific Time.
FCC Compliance Statement
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC rules. These lim-
its are designed to provide reasonable protection against harmful interfer-
ence in residential installations. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance
with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause interference to radio or television equipment
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna
•
Move the equipment away from the receiver
•
Plug the equipment into an outlet on a circuit different from that to
which the receiver is powered
•
If necessary, the user should consult the dealer or an experienced radio/
television technician for additional suggestions
CAUTION: Only equipment certified to comply with Class B (computer
input/output devices, terminals, printers, etc.) should be attached to this
equipment, and must have shielded interface cables.
Finally, any change or modifications to the equipment by the user not
expressly approved by the grantee or manufacturer could void the user's
authority to operate such equipment.
Each APA-358 is equipped with an FCC compliance label which shows only
the FCC Identification number. The full text of the associated label follows:
This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference and (2) this device must accept any inter-
ference received, including interference that may cause undesired
operation.
Adaptec, Inc.
691 South Milpitas Blvd.
Milpitas, CA 95035
Copyright © 1993, 1994 Adaptec, Inc. All rights reserved. Adaptec
and the Adaptec logo are registered trademarks of Adaptec, Inc.
MiniSCSI is a trademark of Trantor Systems Limited, an Adaptec
company. All other trademarks used are owned by their respec-
tive owners.
Printed in Singapore
Stock No.: 510604-00, Rev. A CV 5/94
Information subject to change without notice.
11
Advertisement
Table of Contents
